3 Modes Esc Servo Tester Electronic Speed Controller Checker Master For Rc Car

Instructions for use: Refer to the picture below, the left side is connected to the servo, which is divided into 3 groups of upper, middle and lower, and can be connected to 3 servos; The single-row pins on the right are connected to the power supply, the negative pole near the side (you can see the identification symbol), the negative pole of the battery, do not pay attention to the reverse connection, if the power supply is reversed, the IC will be burned; The pins corresponding to the S identifier are ignored. Turn on the power, the blue light will be on at the same time, and then only the first one on the left will be lit, which is the manual adjustment potentiometer test, press the button, and the middle light will be on, which is the centering test; The third light is on, and the test is automated. The connection method of testing the ESC is the same as that of the servo, but do not connect the power supply at the input end, and the test motor needs to be connected to the ESC first, which is the same as testing the ESC! Features 100% brand new All aluminum alloy shell, anodized treatment, can test analog and digital servos, can control the ESC (motor stepless speed regulation test), and can be the same to test whether the three servos are synchronized (This function is mainly applicable to helicopter servos in CCPM mode.) Servo function 1. With three modes to detect servo or ESC --- manual mode------- you can rotate the potentiometer at different speeds to measure the reaction time. --- slag neutral point mode---- bring the servo back to the neutral point. --- automatic two-brush mode----- which makes the servo oscillate in two brushes at the maximum angle. 2. 1-3 servos can be connected at the same time to test the synchronization, consistency, etc. of 1-3 servos. 3. You can connect 1-3 ESCs at the same time to test and compare their respective reaction times. 4. It can connect 3 servos of CCPM structure helicopter at the same time, and use the neutral position and synchronization functions to screen the debugging helicopter and servo. 5. It can be connected to the servo on the fixed-wing aircraft, and the rudder disc can be installed and debugged by using functions such as neutral position. 6.Fit for 60HZ Servo Specification: Material: aluminum alloy Input Voltage: DC 4.8-6V Size: Approx. 48 * 42 * 17mm / 1.89 * 1.65 * 0.67inch Package List: 1 x Servo Tester

Returns Accepted for this item if it's within 30 Days